- Published in Shops in China
Car compressor from China.
Hello everyone. Once again, while walking around Aliexpress, I came across an original design car pump from China.
This pump from China performs exactly the same functions as all other car pumps, but I liked it because it was made in the form of a car wheel.
A compressor from China is made of plastic in the form of a wheel with a tire on the front side there is a switch and a pressure gauge.
The kit includes additional inflating connectors and instructions in Chinese. Proceeding from the fact that a car pump is not a complicated device, this instruction and nobody needs nafig. In the instructions, you can only understand the figures of the characteristics, which in principle is the most important.
A recess is made along the entire diameter of the wheel in which the hose for fastening is placed. The hose is reinforced and, what is more, it has a metal fitting. The length is about half a meter.
At the bottom of the compressor wheel is a mount for a wire that connects to the cigarette lighter. The wire length is 2.5 meters, which is quite enough. The section is about 1 square.
The cigarette lighter socket is made without a fuse, which is not very good, but if it is fundamentally important to someone, then the fuse can be installed easily by yourself.
To inspect the filling of an automobile pump from China, you need to unscrew four self-tapping screws on the bottom cover. All parts are made with high quality: the compressor itself is in a metal case (serves as a radiator) for heat dissipation, fixed with two metal clamps. Gears, piston and pump casing are made of metal and, oddly enough, were lubricated with blue grease.
According to the instructions, 25 liters per minute are stated, which I doubt very much. I decided to test it on my car and coped with a 13 "wheel without any problems. Heating of the compressor and wires was not noticed. How exactly the pressure gauge located on the compressor corresponds to the indicators after pumping the wheel, I honestly did not check, but at first glance everything is fine. If, for example, for example pump up the wheel and the pressure gauge will show 2 atm, but in real life it will be, for example, 2.1, then nothing bad will happen. The main thing is that all the wheels are pumped equally well, or as it should be according to the instructions for each car.
Sentence : Recommended for purchase. As an original gift it will be just super.